Page 1
A SMALL AMOUNT OF PANEL FLEX IS COMMON IN WOOD PRODUCTS. LES BOIS DURS VÉRITABLES UTILISÉS DANS LE MOBILIER BELL'O SONT NATURELLEMENT BEAUX. CERTAINES VARIATIONS DANS LE GRAIN DU BOIS SONT NORMALES ET SOUHAITABLES. VEILLER À UTILISER EXCLUSIVEMENT UNE CIRE POUR MOBILIER EN BOIS DE HAUTE QUALITÉ POUR L'ENTRETIEN DE CE MEUBLE.
Page 2
! NE PAS GRIMPER NI MARCHER SUR LE MEUBLE. ! NE PAS TAPER NI S’APPUYER SUR LES PLATEAUX. Bell'O International Corps décline toute responsabilité en cas d'assemblage non conforme aux instructions ou pour l'assemblage, l'utilisation ou la manutention incorrects de ce meuble.
Page 3
PARTS LIST / NOMENCLATURE DES PIÈCES / LISTA DE PIEZAS Quantity Quantity Part / Pièce / Pieza Part / Pièce / Pieza Quantité Quantité Cantidad Cantidad...
Page 4
ASSEMBLY INSTRUCTIONS INSTRUCTIONS D’ASSEMBLAGE INSTRUCCIONES DE ENSAMBLAJE NOTE: 2 PEOPLE ARE RECOMMENDED TO ASSEMBLE THIS FURNITURE. TO AVOID DAMAGE DURING ASSEMBLY, IT SHOULD BE ASSEMBLED ON A SOFT SURFACE. REMARQUE : IL EST CONSEILLÉ D’ÊTRE À DEUX POUR ASSEMBLER CE MEUBLE. POUR ÉVITER LES DOMMAGES, EFFECTUER L'ASSEMBLAGE SUR UNE SURFACE DOUCE.
Page 5
Fig. 2 2. INSERT three Dowels (TP7) into each hole in the rear edge of the Cabinet Bottom Panel (TP2). 3. ATTACH the Cabinet Bottom Panel (TP2) to the Cabinet Back and Sides (TP6) as shown. 4. ALIGN the latch hooks on the Side Panels with the latches on the Bottom Panel (TP2), and TURN the latches under the Bottom Panel to LOCK the parts together.
Page 6
Fig. 3 5. PLACE seven Dowels (TP7) into the holes in the top edges of the Back and Side Panels (TP6) as shown. ALIGN the Cabinet Top (TP3) with the Dowels and press Cabinet Top firmly to attach. 6. TURN the latches on the inside of the Cabinet Side Panels to LOCK the parts together. 5.
Page 7
Fig. 4 7. PLACE two Dowels (TP7) into the holes in the top posts of the Back and Side Panels (TP6) as shown. 8. ALIGN the Top Shelf (TP1) with the Dowels and press Top Shelf down firmly to attach. 7.
Page 8
Fig. 5 9. PLACE fourteen Dowels (TP7) into the predrilled holes in the front edges of the cabinet as shown. 10. ALIGN the Cabinet Front (TP5) with the Dowels and press Cabinet Front downward firmly to attach. 11. TURN the latches on the inside of the Cabinet Side Panels (TP6) and under the Bottom Panel (TP2) to LOCK the parts together.
Page 9
Fig. 6 12. TURN the cabinet upright with the help of an assistant. INSERT four Shelf Support Posts (TP8) into the predrilled holes in the inside of the cabinet Sides (TP6) at the desired height. ANGLE the Shelf (TP4) and CAREFULLY PLACE it into the cabinet and down onto the Shelf Support Posts.
Page 10
INTERCHANGEABLE GLASS OR WOOD DOOR PANELS PANNEAUX DE PORTE EN VERRE OU EN BOIS INTERCHANGEABLES PANELES DE PUERTAS INTERCAMBIABLES DE MADERA O VIDRIO Fig. 7 Glass Verre Vidrio Wood Bois Madera 13. This cabinet comes with two sets of door panel inserts (glass or solid wood). To interchange any of the door panel inserts, CAREFULLY REMOVE the rubber gasket from the inside door frame.
Page 11
This warranty gives you specific legal rights. You may also have other rights, which vary from state to state. BELL'O INTERNATIONAL CORPORATION, 711 Ginesi Drive, Morganville, NJ 07751-1235 Phone: (732) 972-1333 Fax: (732) 536-6482 Web: www.bello.com E-mail: sales@bello.com...
Garantía limitada de un (1) año Se le garantiza al comprador original este producto Bell'O International Corporation, con excepción del vidrio, durante un período de un (1) año a partir de la fecha de la compra. Se le garantiza al comprador original el vidrio durante un período de treinta (30) días a partir de la fecha de la compra. Esta garantía se limita expresamente a los productos nuevos comprados en cajas cerradas en fábrica.