Table of Contents
Advertisement
4 Pull the black handle on the sankey keg coupler and press it
downward until it locks into position. The keg is now tapped.
5 Insert the keg(s) into the kegerator.
Adjusting the CO
1 Make sure that the shut-off valve is closed (sideways if closed, down if
open), then slowly turn the main valve on the CO
counter-clockwise until it is fully open.
2 Open the shut-off valve to allow gas to flow into the keg.
3 Release the adjustment lock nut, behind the regulator screw, by
turning it clockwise about 5-7 turns.
Note
If beer comes up through the top of the wing nut, remove the
wing nut, reposition the washer, then reattach the wingnut.
regulator
2
Open
www.insigniaproducts.com
Dual Beer Kegerator/Beverage Cooler
Sankey keg coupler
tank
2
Shut-off valve
Closed
15
Advertisement
Table of Contents
