Cisco 3600 Series Upgrade Instructions page 26

Upgrading System Memory in Cisco 3745 Routers
Figure 14
Reinstall the chassis on a rack or desktop.
Step 7
Proceed to the
Step 8
Replacing Connections to the Router
To make final connections to the router, follow these steps:
Replace all network connections.
Step 1
Do one of the following:
Step 2
•
•
Turn ON the power switch. The power LED on the front panel of the router should come on.
Step 3
Check the Sys LED on the right side of the front panel to verify that it goes on after a few seconds delay
Step 4
when booting.
If you have problems, see the
Step 5
Proceed to the
Step 6
Upgrading System Memory in Cisco 3700 Series Routers
26
Captive Screws on a Cisco 3745 Router
"Replacing Connections to the Router" section on page
AC-powered router: Plug the power cord into a 3-terminal, single-phase power source that
provides power within the acceptable range (100 to 240 VAC, 50 to 60 Hz).
DC-powered router: Remove the tape from the circuit breaker switch handle and reinstate power
by moving the handle of the circuit breaker to the ON position.
"Obtaining Technical Assistance" section on page
"Recovering Compact Flash Memory and System Images" section on page
26.
28.
27.
OL-5423-02