Replacing Compactflash Memory Cards - Cisco 3600 Series Upgrade Instructions

Hold the SODIMM component-side up, with connector edge (the metal fingers) away from you. Keep
Step 3
the sides of the SODIMM between your thumb and middle finger, with your forefinger against the far
edge and opposite the connector edge. (See
Figure 11
Tilt the SODIMM to the same angle as the socket, then insert the connector edge into the socket. Gently
Step 4
push into place until the plastic clips snap into place.
Caution It is normal to feel some resistance when installing a SODIMM, but do not use excessive force and do
not touch the surface components.
Check the two alignment holds and ensure that the plastic clips are visible. If necessary, carefully remove
Step 5
and reseat the SODIMM.
If necessary, repeat
Step 6
Proceed to either of the following as appropriate:
Step 7
•
•

Replacing CompactFlash Memory Cards

To install a new CompactFlash memory card, follow these steps:
Refer to Installing and Formatting Cisco 2691, Cisco 3631, and Cisco 3700 Series CompactFlash
Step 1
Memory Cards, available online at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis3700/hw_inst/hw_notes/
index.htm
Proceed to
Step 2
OL-5423-02
Handling a SODIMM
Step 3 through
"Replacing CompactFlash Memory Cards" section on page 23
"Replacing the Cisco 3745 Mainboard" section on page 24
"Replacing the Cisco 3745 Mainboard" section on page
Upgrading System Memory in Cisco 3745 Routers
Figure 11.)
Step 5 to install the top SODIMM.
Upgrading System Memory in Cisco 3700 Series Routers
24.
23