Raider PRO RDP-SAC20 solo User Manual page 21

21
Keep pulling the switch trigger until the tool stops. The item is inflated with the specified
pressure.
1. Air chuck clamp 2. Air chuck 3. Sport ball needle 4. Tapered adapter 5. Beveled adapter
NOTICE: When inflating a floating tube, the pressure gauge will not display an accurate value
since the pressure of floating tube is less than 20 kPa (3 PSI). When inflating a floating tube,
do not use the value on the pressure gauge, but inflate it by checking the status of the floating
tube.
MAINTENANCE
CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed
before attempting to perform inspection or maintenance.
NOTICE: Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or
cracks may result.
PUMPING
1.Turn the tire valve so that it is closest to the ground. Then place the compressor as close to the
tire as possible.
2.Insert the hose with the appropriate nozzle into the outlet for inflating the tire;
3.When the desired tire pressure is reached, remove the nozzle hose from the tire valve.
ADAPTERS
To use any of these adapters, you need to put it in the compressor hose. The pressure to be
inflated when inflating a rubber boat with two seats or a soccer ball is of the order of 100 psi.
In case the compressor does not start:
Check that the valve is fully inserted and that the gripper is tight.
In case the compressor starts but does not supply air:
Make sure that the pump valve is placed tightly on the tire valve;
In case the compressor runs slowly:
The possible cause may be overload;
Voltage too low. Check the battery status
Important!
Compressor capacity is 100 psi. Never attempt to raise the pressure above the allowable limits
described in this manual.
Do not leave the compressor unattended in operation.
Keep the compressor away from children.