Advertisement
Available languages
Available languages
18
www.raider.bg
value between 20 kPa (3 PSI) and 690 kPa (100 PSI).
LITHENING UP THE FRONT LAMP
CAUTION: Do not look in the light or see the source of light directly.
Pull the switch trigger while the LCD display light on to light up the work lamp. The lamp
keeps on lighting while the switch trigger is being pulled. The lamp goes out immediately
after releasing the switch trigger.
NOTE: Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the
lens of lamp, or it may lower the illumination.
ASSEMBLY
CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed
before carrying out any work on the tool. Attaching or removing the extension tube:
1. Lock nut 2. Air outlet 3. Extension tube with adapter
To attach the extension tube onto the tool, perform the following steps:
1.Loosen the lock nut by turning it anticlockwise a little.
2.Insert the adapterof the extension tube into the
air outlet as far as it can go a little bit hard.
3.Secure the lock nut by turning it clockwise firmly
To remove the extension tube from the tool, perform the installation procedure in reverse.
CAUTION: After attaching the extension tube , make sure that it is inserted into the right
place and firmly secured.
STORING ADAPTER AND NEEDLE
Advertisement
