Advertisement
Available languages
Available languages
17
26.Do not use the tool in locations where the temperature may go -10 °C (14 °F) or less, or, 40
°C (104 °F) or more.
PURPOSE
Attention! Compressor RDP-SAC20 solo is designed for inflating vehicle tires (bicycles), balls,
rubber mattresses, inflatable toys, etc.
Attention! Never leave the compressor unattended in operation. It is not suitable for pumping
up large-volume tyres (e.g. truck tyres) or large inflatable items (e.g. air mattresses).The air
pump is intended only for household and domestic use.
NOISE
The typical A-weighted noise level determined accord- ing to EN62841-1:
Sound pressure level (LpA) : 80.5dB(A) or less Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 90 dB (A).
VIBRATIONS
The vibration total value (tri-axial vector sum) deter- mined according to EN62841-1:
Work mode: operation without load
Vibration emission (ah) : 2.5 m/s2 or less Uncertainty (K) : 1.5 m/s2
ON/OFF
1. Switch trigger of power switch
The tool provides two ways to start on. For the first way, simply depress the switch trigger
once, when the LCD display light on about 3 seconds later, depress the switch trigger again.
For the second way, first depress the LCD On/off and unit change button once, when the LCD
display light on about 3 seconds later, depress the switch trigger. Release the switch trigger to
stop the tool.
1. LCD On/off and unit change button 2. Minus button 3. Plus button 4. LCD display
If the object to be inflated is connected to the tool, the air pressure of the object is displayed
on the pressure gauge when you turn on the tool. If nothing is connected to the tool, the
pressure gauge displays "0".
You can set the air pressure on the pressure gauge. To change the unit from "Bar" to "PSI",
press the LCD On/off and unit change button. To increase the pressure value, press the plus
button. To decrease the pressure value, press the minus button. You can set the pressure
Advertisement
