Pre-Installation; Installation - Feit Electric TR2X4G2/6WY/WH Important Safety Instructions And Installation Manual

Pre-Installation

TOOLS/HARDWARE REQUIRED:
Phillips Screwdriver

Installation

1
Turn the power OFF at the switch and fusebox
or the circuit breaker.
2
Remove the wire connection cover on the
fixture, by using a phillip screwdriver.
3
Remove 1/2" knockout by using a flat
screwdriver (See fig.1).
fig. 1
1/2 in.
Knockout
Flat Screwdriver 1/2 in Conduit Connector
(Not provided)
4
Install the 1/2 in conduit connector (not provided)
on the knockout hole (See fig.2).
fig. 2
1/2 in. Conduit
Connector
5
Make sure power is off from the circuit breaker or fuse.
Feed the conduit and the building supply wires through the
conduit connector.
1/2 in. Conduit
Connector
Conduit
3
WWW.FEIT.COM
RETAIN THIS MANUAL FOR FUTURE USE