Table of Contents
Advertisement
Information on the display panel
Display
Õ
|
E:18
E:32
w lights up
o lights up
k flashes
Other displays
Cause/Remedy
Flashes fast + warning signal: The door was opened and the water level is
■
too high. Close the door, continue the programme with Start/Reload button or
select Spin 0 programme.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
Flashes (no water supply): Tap turned on? Filter in the water supply is
■
blocked?
~ "Filter in the water supply is blocked" on page 33
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
Is the drain pump blocked?
~ "Drain pump is blocked" on page 32
Is the drain hose at the siphon blocked?
~ "The drain hose at the siphon is blocked" on page 33
Alternating display with End when programme is finished: unbalance problem, spin-
ning phase is aborted.
The childproof lock is activated – deactivate it.
Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
Run the k Drum clean programme to clean and care for the drum and the outer
tub.
Notes
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
■
only use half the amount of detergent recommended by the detergent manufac-
turer. Do not use detergent designed for woollens or delicates.
Switching the information signal on/off.
■
Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call customer services.
Faults and what to do about them
en
35
Advertisement
Table of Contents
