Table of Contents
Advertisement
DIVAR IP 7000 1U
3.3.2
Rack precautions
Warning!
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
!
precautions to ensure that the system remains stable. The following guidelines are provided
to ensure your safety:
–
–
–
–
–
–
–
–
3.3.3
General system precautions
–
–
–
–
–
–
See also:
–
3.3.4
Rack mounting considerations
Ambient operating temperature
If installed in a closed or multi-unit rack assembly, the ambient operating temperature of the
rack environment may be greater than the ambient temperature of the room. Therefore,
consideration should be given to installing the equipment in an environment compatible with
the manufacturer's maximum rated ambient temperature (Tmra).
Reduced airflow
Equipment should be mounted into a rack so that the amount of airflow required for safe
operation is not compromised.
Mechanical loading
Equipment should be mounted into a rack so that a hazardous condition does not arise due to
uneven mechanical loading.
Bosch Sicherheitssysteme GmbH
Ensure that the leveling jacks on the bottom of the rack are fully extended to the floor
with the full weight of the rack resting on them.
In single rack installations, attach stabilizers to the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or
servicing the unit in the rack.
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top
with the heaviest component at the bottom of the rack.
In multiple rack installations, couple the racks together.
Always make sure the rack is stable before extending a component from the rack.
Extend only one component at a time - extending two or more simultaneously may cause
the rack to become unstable.
Review the electrical and general safety precautions that came with the components you
are adding to your chassis.
Determine the placement of each component in the rack before installing the rails.
Install the heaviest components on the bottom of the rack first, and then work up.
Use a regulating uninterruptible power supply (UPS) to protect the system from power
surges, voltage spikes if you want to keep your system operating in case of a power
failure.
Allow the SATA hard drives and power supply modules to cool before touching them.
Always keep the rack's front door and all panels and components on the system closed
when not servicing to maintain proper cooling.
Safety precautions
Quick Installation Guide
System setup - hardware | en
2013.10 | V1 | DOC
11
Advertisement
Table of Contents
