Table of Contents
Advertisement
CAUTION
Fitted assembly plate CV
33, CV 34
CAUTION
© Copyright 2016 ABB. All rights reserved.
Taking out of operation at short notice
Locking the rotor
Don't remove any balancing screws from the compressor wheel. Use
only free threaded holes to fit the lifting device.
Put assembly/disassembly device (90020) over studs (74026) and lift-
ing device (90427).
Turn compressor wheel until holes in lifting device (90427) align with
holes in assembly/disassembly device (90020).
Fasten assembly/disassembly device to lifting device (90427) using
screws (94006).
Secure assembly/disassembly device (90020) to compressor housing
by screwing nuts (74027) onto studs (74026). (See also chapter Table
of tightening torques.)
Make sure all components are clean and free from grease.
Operation Manual / TPL76-C
9
9.2
Page 132
Advertisement
Table of Contents
