Table of Contents
Advertisement
© Copyright 2016 ABB. All rights reserved.
Disassembly and assembly
Installing cartridge group
Fitting compressor casing internal part
* The two compressor casing parts are centred via the long cylindrical
flange. No guide pieces are needed.
Check whether the nuts (90458) of the three safety segments have
been tightened (safety segments are in the "not engaged" position).
Fit O-ring (76040).
Remove the support angle (90025), screws (90021) and nuts (74027).
Align the compressor casing internal part (76000) with the compressor
casing external part as shown in the illustration on the next page.
Carefully insert the compressor casing internal part (76000) including
the wall insert and diffuser into the compressor casing external part
and then remove the lifting device (90190/90195).
Operation Manual / TPL76-C
8
8.7
Page 113
Advertisement
Table of Contents
