Table of Contents
Advertisement
NOTICE
Check
© Copyright 2016 ABB. All rights reserved.
Disassembly and assembly
Dismantling and fitting nozzle ring at
turbine end
In only one of the three segments is there a roll pin as an aid when po-
sitioning the gas inlet casing. This segment fits in only one position in
the gas inlet casing (note the circle in the illustration). Consequently,
begin with this segment.
Put remaining segments (51012) in place on gas inlet casing (51001)
and fit them loosely using screws (61044).
Replace centering bolts (90177) with screws (61044).
Collars (C) of segments (51012) must be in groove (S).
Operation Manual / TPL76-C
8
8.8
Page 121
Advertisement
Table of Contents
