BE Power Equipment HW2765HG Operator's Manual page 13

OPERATION
HOT WATER BURNER START UP PROCEDURE
Once the engine is running, and fuel tank for the burner is filled with diesel.
Push the burner toggle switch into the ON position and adjust the thermostat to the desired temperature.
Once the heater has been started, the water will begin heating up in about 20 seconds. It will reach
maximum temperature within 2.5 minutes of continues spraying through the gun. The burner will not fire
The water temperature can become extremely hot during operation.
APPLYING DETERGENT
This feature is designed for use with mild detergents only. Since the cleaning solution travels through
the heat exchanger coil, DO NOT use corrosives as they will cause extensive damage as well as pose a
considerable safety hazard.
1. Prepare detergent solution according to label directions. Never pump acids, alkaline, abrasive fluids or
solvents through the unit. Due to the unknown and often corrosive characteristics of many detergents
commonly used in the pressure washer cleaning industry, it is recommended to use only mild detergents
with this unit.
2. Fully immerse the detergent strainer into the detergent solution.
3. To apply solution, install the black soap nozzle to the tip of the spray gun, unlock the gun, and squeeze
the trigger. After a few moments, a detergent/water mixture will exit the nozzle. Start spraying the lower
portion of the surface being cleaned and move up, using long overlapping strokes. Applying from the
bottom up helps avoid streaking. Allow everything to soak briefly.
4. Avoid working on hot surfaces or in direct sunlight to minimize the chances of the detergent drying,
which may result in damaged surfaces. Be certain to rinse a small section at a time.
5. To rinse, lock the trigger gun in the "OFF" position. From here, securely place the white or green spray
tip in the end of the spray gun. Unlock the trigger and spray. It will take about 30 seconds to purge all
detergent from the line. For best rinsing results, start at the top and work down.
6. Siphon a gallon of water through the low pressure detergent injection system after each use. This
prevents the possibility of corrosion or detergent residue causing mechanical problems during the next use.
BEPOWEREQUIPMENT.COM
NOTICE
when the trigger is released.
WARNING
Use caution when operating the spray gun.
HOUR METER
TACH / HOUR
OFF
THERMOSTAT
21
Thermostat
NOTICE
4 3
B
A
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
<INSERT COMPANY NAME HERE>. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
<INSERT COMPANY NAME HERE> IS
PROHIBITED.
4 3
ON
ON/OFF
Toggle Switch
OFF
BURNER
2 1
B
A
UNLESS OTHERWISE SPECIFIED: NAME DATE
DIMENSIONS ARE IN INCHES DRAWN HAMID L 10/04/19
TOLERANCES: TITLE:
FRACTIONAL CHECKED LOW PRESSURE CHEMICAL
ANGULAR: MACH BEND
ENG APPR.
TWO PLACE DECIMAL INJECTOR, 4000PSI, 2.5GPM,
THREE PLACE DECIMAL
MFG APPR.
3/8"QC, 3/8:" PLUG
INTERPRET GEOMETRIC Q.A.
TOLERANCING PER:
COMMENTS:
MATERIAL SIZE DWG. NO. REV
B
BRASS- STAINLESS STEEL 85.400.001(R2)
FINISH
NEXT ASSY USED ON
APPLICATION DO NOT SCALE DRAWING SCALE: 1.5:1WEIGHT: SHEET 1 OF 1
2 1
13