General Safety Instructions; Product Features - Dyna-Glo WORKHORSE FA43 Series User's Manual And Operating Instructions

Propane construction heater
Table of Contents

Advertisement

PROPANE CONSTRUCTION HEATER
Accidents are always tragic especially because so many of them could have been prevented with little care
and judgment. There are some basic good practices, we hope you will follow for safe use of your heater.
• Children should be carefully supervised, when they are in the area.
• Always maintain proper clearance from combustible materials. Minimum clearance from combustibles:
Side - 24" (61 cm); Top - 36" (92 cm); Front - 72" (183 cm). Floor - combustible. Not for use on finished floors.
• Heater must be placed on level and stable surface.
• Never place anything including clothes or other flammable items on the heater.
• The appliance area shall be kept clear and free from combustible materials, gasoline and other flammable
vapours and liquids.
• Do not modify or operate a heater which has been modified.
• Adequate clearance for accessibility and for combustion & ventilation air supply must be maintained at all times
when the heater is operating.
• Service and repair should be done by a qualified service person. The heater should be inspected before each
use and at least annually by a qualified person. More frequent cleaning may be required as necessary. Do not
service while hot or operating.
• Never connect heater to an unregulated gas supply.
• The heater is shipped from the factory for LP(Propane) gas. This heater is for use with propane gas only, do not
convert heater to any other gas. Installation must conform to local codes or, in the absence of local codes, with
the standard for the Storage and Handling of Liquefied Petroleum Gases ANSI/NFPA 58 and the Natural Gas
and Propane Installation Code CSA B149.1
• The minimum and maximum inlet pressures to the regulator from the gas tank are 5 psi and bottle pressure,
respectively. Use only the regulator & hose assembly provided with the heater. Inspect the regulator/hose
assembly prior to each use of the heater. If there is excessive abrasion or wear, or hose is cut, replace with
regulator/hose assembly listed on the parts list prior to using this heater.
• Gas supply connections should be checked using a 50/50 solution of liquid dish soap and never use a flame to
check for gas leaks.
• The electrical connection & grounding must comply with National Electrical Code. ANSI/NFPA 70 or in Canada
CSA C22.1, Canadian Electrical Code, Part 1. Use only a properly grounded three (3) prong receptacle.
• Do not restrict inlet or outlet by any means. The flow of combustion and ventilation air is not to be obstructed.
• This heater should not be directed toward any propane-gas container within 20 ft (6M). The heater must be
located at least 6 ft. (1.83 m) in the U.S.; or (ii) 10 ft. (3 m) in Canada, from any propane gas container.
• The propane cylinder supply system must be arranged to provide for vapour withdrawal from the operating
cylinder.
• This heater is not to be used with external thermostats, timers or other devices that control or alter electrical
supply to the heater.
• Heater must be placed on a flat stable surface. Do not position the heater at any other angle than the intended
design position. Certain models can change the up and down tilt angle by loosening the "height control screw"
and moving the "height controller", then retightening the "height control screw".
• This heater is not designed to thaw ground surfaces.
• Installation of this Appliance at altitudes above 2000 ft. (610 m) shall be in accordance with local codes, or
in the absence of local codes the, National Fuel Gas Code, ANSI Z223.1 / NFPA 54, or National Standard of
Canada, Natural Gas and Propane Installation Code, CSA B149.1.
WARNING
: Motor and fan must be running before lighting, during operation and at shutdown,
in order to prevent a flame-out condition which could result in personal injury or property damage.
• Portable & Stable
• Wind Resistant & Rain Protected
• Piezo Electric Spark Ignition
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
GENERAL SAFETY INSTRUCTION
IMPORTANT SAFETY INSTRUCTION

PRODUCT FEATURES

• 100% Safety Shutoff System
• Continuous Adjustable Input Rating
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workhorse lpfa43wh

Table of Contents