Motorcycle mount amplified 50 watt x 2 stereo sound system with dual handlebar mount speakers/power on/off remote control/3 way crossover cycle series (3 pages)
CONTENTS Installation ..........3 DISPLAY INFORMATION ....10 Take out screw before installation ..3 USB play operation ......10 DIN Front-Mount (Method A) ....3 Disc notes.......... 11 Remote control ........ 12 Installing the unit ....... 3 Specification ........13 Removing the unit ......
INSTALLATION Notes: TAKE OUT SCREW BEFORE INSTALLATION Choose the mounting location where Before install the unit, please remove the the unit will not interfere with the two screws. normal driving function of the driver. Before finally installing the unit, connect Take out screw before installation.
INSTALLATION back of the unit in place. Use the supplied they will go (with the notches facing up) hardware (Hex Nut (M5mm) and Spring into the appropriate slots at the middle Washer) to attach one end of the strap to left and right sides of the unit.
INSTALLATION To fasten the unit to the factory radio 4. Lift the top of the outer trim ring then mounting brackets. pull it out to remove it. Align the screw holes on the bracket with 5. Insert both of the supplied keys into the screw holes on the unit, and then tighten the screws (5x5mm) on each side.
OPERATION TURN ON/OFF THE UNIT Rotating the audio knob (2) to change the Press button (1) to turn on the unit. minute. Then press DISP button to confirm. When the unit is on. Press and hold it for 2 seconds to turn off the unit. LIQUID CRYSTAL DISPLAY SOUND ADJUSTMENT Exhibit current frequency and activated...
OPERATION to activate automatic seek function. It begins. will search up/down station If a CD is already inserted in the driver: automatically. Press for 2 seconds until “MANUAL” appears on the display, the Keep pressing MODE button (1) manual tuning mode is selected. In this until the CD mode display appears.
OPERATION DISP button (7) is assigned as selection KEY Assigned IN Searching mode (Table 1) button in MP3/WMA operation. AS/PS Mode Select When pressed, it is activated as selecting ENTER each mode as below: A, B, C, 1 Search file number => Search File D, E, F, 2 Name=>Search from folder.
OPERATION 2.The unit cannot play a CD-R and CD-RW support every MP3 player. When connecting an MP3 player and that is not finalized. (Please refer to the there has normal battery in the player manual of your CD-R/CD-RW recorder or (non rechargeable battery), you should CD-R/CD-RW software for more remove the battery from the MP3...
REMOTE CONTROL HANDSET(OPTIONAL) FUNCTION KEY & CONTROL 1. POWER Power ON/OFF Button 2. 7/MODE Mode Button(S,T,U,7,For MP3/WMA Operation) 3. TUNE/SKIP Tune/SKIP Down Button(V,W,X,8 For MP3/WMA Operation) 4. BND(LOU/ENT) Band Select Button(When pressed shortly) Loudness Button (When pressed long) (Enter Button For MP3/WMA Operation) 5.
SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground 7''W x 7''D x 1.96''H Chasses Dimensions Tone Controls Bass (at 100 Hz) : ±10 dB Treble (at 10 kHz) : ±10 dB Maximum Output Power : 4x50 watts Current Drain : 10 Ampere (max.) (For Normal Power Version) CD PLAYER...
TROUBLE SHOOTING Before going through the checklist, check wiring connection. If any of the problems persist after checklist has been made, consult your nearest service dealer. Symptom Cause Solution The car ignition switch is power supply No power. not on. connected to the car accessory circuits, but the engine is not moving, switch the ignition key...