Pyle PLRDD19UB Owner's Manual

Pyle PLRDD19UB Owner's Manual

Mobile audio system

Advertisement

Quick Links

PLRDD19UB
OWNER'S MANUAL
Mobile Audio System
 PLL Synthesizer Stereo Radio
 MP3/WMA Player
 Automatic Memory Storing
 Preset Equalization
 USB/SD card Interface
1

Advertisement

Table of Contents
loading

Summary of Contents for Pyle PLRDD19UB

  • Page 1 PLRDD19UB OWNER’S MANUAL Mobile Audio System  PLL Synthesizer Stereo Radio  MP3/WMA Player  Automatic Memory Storing  Preset Equalization  USB/SD card Interface...
  • Page 2: Table Of Contents

    CONTENTS Installation ........... 3 SD card operation………………………9 Wiring Connection ......5 Bluetooth operation……………………...10 Remote control ........12 Operation ..........6 Specification ........13 Location of keys ........6 Trouble shooting ......... 14 Switching on/off the unit ......7 Sound adjustment ......... 7 EQ function ...........
  • Page 3: Installation

    INSTALLATION threaded screw holes at the sides of Notes: the unit chassis). For details, refer to Choose the mounting location the following illustrated installation where the unit will not interfere methods. with the normal driving function Installation Opening of the driver. This unit can be installed in any Before installing the unit, connect dashboard having an opening as...
  • Page 4 INSTALLATION...
  • Page 5: Wiring Connection

    WIRING CONNECTION ISO CONNECTION...
  • Page 6: Operation

    OPERATION LOCATION OF KEYS 11. SD slot 12. 9/ 2 INT 13. 0/ DISP 3 RPT 14. Reset button 15. PUSH/SEL/PWR 5 DIR-/* /MODE 4 RDM 17. 8/ 6 DIR+/# /7/BAND AUX IN 19. AS/PS/TRANS 10. USB interface...
  • Page 7: Switching On/Off The Unit

    OPERATION SWITCHING ON/OFF THE UNIT either a ballpoint pen or thin metal object. Press PWR button (15) to turn on/off the The RESET button is to be activated for unit. When the unit is on. Press and hold it the following reasons: for 2 seconds to turn off the unit.
  • Page 8: Station Storing

    OPERATION - Automatic memory storing MONO mode. The noise will be Press AS/PS/TRANS button (19) for 2 reduced. seconds the radio searches from the USB PLAY OPERATION 87.5MHz frequency and checks the signal In the front panel of the unit, there is strength until one cycle search is finished.
  • Page 9: Selecting Directory Up/Down

    OPERATION does not contain any directory, there is selected file is a song, it starts to no function of pressing DIR-/*button (6) play. or DIR +/# button (8). SELECTING TRACKS AS/PS  DISPLAY INFORMATION BUTTON KEY Assigned IN Searching mode AS/PS/TRANS button (19) is assigned (Table 1) selection...
  • Page 10: Bluetooth Operation

    OPERATION button to select SD mode. 1) On the mobile phone, select the Bluetooth set up. (Please refer to the Note: instruction manual of your mobile The main unit can only support the standard USB-memory device which is phone on how to operate Bluetooth.) approved by Microsoft.
  • Page 11 OPERATION Call out The call will not be able to dial out 1) Making an outgoing call by because your mobile phone will ask inputting the phone number you which SIM card will be used to manually. dial out. You have to confirm use Press MOD key it will show “PHONE”...
  • Page 12: Remote Control

    REMOTE CONTROL HANDSET(OPTIONAL) FUNCTION KEY & CONTROL 1. POWER Power ON/OFF Button 2. MODE Mode Button(S,T,U,7,For MP3/WMA Operation) 3. TUNE/SKIP Tune/SKIP Down Button(V,W,X,8 For MP3/WMA Operation) 4. 7/BND Band Select Button(When pressed shortly) 5. SCN Scanning Button(D,E,F,2 For MP3/WMA Operation) 6.
  • Page 13: Specification

    SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 7" (W) x 6.2" (D) x 3.9"(H) Tone Controls Bass (at 100 Hz) : ±10 dB Treble (at 10 kHz) : ±10 dB Maximum Output Power Version V : 4x60 watts Current Drain...
  • Page 14: Trouble Shooting

    TROUBLE SHOOTING Before going through the checklist, check wiring connection. Symptom Cause Solution The car ignition switch is power supply No power. not on. connected to the car accessory circuits, but the engine is not moving, switch the ignition key to “ACC”.

Table of Contents