Installing The Rear Axle/Final Drive Assembly - Yamaha 5YF2-AE1 Service Manual

REAR AXLE/FINAL DRIVE ASSEMBLY AND DRIVE
SHAFT
EBS00196
INSTALLING THE REAR AXLE/FINAL
DRIVE ASSEMBLY
1. Lubricate:
• drive shaft
• coupling gear
• O-ring
• oil seal
• bearing
Lithium-soap-based grease
2. Install:
• drive shaft
• coupling gear
(to the universal joint)
3. Install:
• rear axle/final drive assembly
M MMM M MMM M M MMM
a. Apply sealant (Quick Gasket
bond No. 1215 to the mating surfaces of the
swingarm and the final gear case.
Sealant (Quick Gasket
P/N. ACC-11001-05-01
Yamaha bond No. 1215
P/N. 90890-85505
b. Temporarily install the rear axle/final drive
assembly 1 on the swingarm 2. The bolts
and nuts should be temporarily tightened.
c. Check that the rear axle rotates smoothly.
d. Tighten the bolts and nuts.
1 Rear axle/final drive assembly
2 Swingarm
3 Bolt (× 4)
4 Nut (× 3)
5 Bolt (× 6)
Bolt 3
20 Nm (2.0 m · kg, 14 ft · lb)
Nut 4
40 Nm (4.0 m · kg, 29 ft · lb)
Bolt 5
20 Nm (2.0 m · kg, 14 ft · lb)
LOCTITE
L LLL L LLL L L LLL
6 - 12
DRIV
M M MMM M M MMM M
®
) or Yamaha
®
)
®
L L LLL L L LLL L
M MMM M MMM
L LLL L LLL