Generate A Burst Waveform - FeelTech FY2300H Series User Manual

Generate a Burst Waveform

This instrument can output a burst (waveform with specified number of cycles)
using standard waveforms such as sine, square, Triangle/ramp, and noise, or
arbitrary waveforms. The instrument supports control of burst output by internal
CH2, manual and external trigger source.
Enable Burst Function
Press ▼
button to enter burst function. Then press TRIG button to select trigger sources
from " CH2", "Ext." and "MANU". Then the generator will output burst waveform
according to current configuration.
When the burst function is enabled, press
burst. Use arrow buttons and ADJ Knob to set the numbers from 1 to 1048575.
 NORMAL: The Burst function is disabled。
 CH2 Trigger: CH1 will generate a burst when CH2 generates a pulse.
 Ext. Trigger: CH1 will generate a burst when EXT.IN connector was inputted a
pulse.
 MANU Trigger: User can trigger a burst by pressing ADJ Knob (OK button).
FY2300H Series User's Manual
button in CH1 parameter setting status. Then press "TRIG"
No.
button to set the cycles of
FeelTech
25