Furniture of America CM7561EK Assembly Instructions Manual

For more information contact our team: service.ec@foagroup.com

ASSEMBLY RATING

The Assembly Rating is a 5-point system that

shows the degree of effort needed in

assembling a specific product (with 1 being

easy and 5 being difficult). For some

products, two persons are recommended.

EASY

Assembly Instructions

DIFFICULT

CM7561EK

Tools Required For Assembly:

Allen Wrench

Phillips Screwdriver

Wrench

2 PERSONS RECOMMENDED

Page 1 of 6

(Included)

(Not Included)

(Included)

Rev: 18-07-17

Table of Contents

Do you have a question about the CM7561EK and is the answer not in the manual?

Page 1 Assembly Instructions For more information contact our team: service.ec@foagroup.com CM7561EK ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that Allen Wrench shows the degree of effort needed in (Included) assembling a specific product (with 1 being Phillips Screwdriver easy and 5 being difficult).
Page 2 LOOSEN OVER TIME AND MAY CAUSE THE FURNITURE TO BE WOBBLY AND UNABLE TO SUPPORT ITS INTENDED WEIGHT CAPACITY. THIS MAY LEAD TO COLLAPSE AND MAY CAUSE SERIOUS INJURY. FAILURE TO FOLLOW THE GUIDELINES ABOVE MAY RESULT IN INJURY AND/OR PROPERTY DAMAGE. FURNITURE OF AMERICA.ALL RIGHTS RESERVED. Page 2 of 6...
Page 3 Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. #A x 14pcs #1 x 1pc Bolt Ø5/16"x1-3/4" Headboard panel #B x 14pcs #2 x 2pcs Lock washer Ø5/16"...
Page 4 Exploded View #A x 14pcs #B x 14pcs #C x 14pcs Align HB legs (#2R/L) to the holes of the headboard (#1) and HB support (#7), then secure by using bolts (#A) with washers (#B,C). Page 4 of 6...
Page 5 Attach threaded pins (#E) to the headboard (#1) and footboard (#3), then align the side rails (#4) to the threaded pins (#E). Secure by using hex nut (#F) with washer (#G). #E x 8pcs #F x 8pcs #G x 8pcs Attach support legs (#6) to the bed slats (#5).
Page 6 Align slats (#5) to the side rails (#4), then secure by using screws (#I). #I x 8pcs ASSEMBLY IS COMPLETED Page 6 of 6...