Adding More Laundry Or Removing Laundry; Cancelling The Programme; Programme End; Removing Laundry And Switching Off The Appliance - Siemens WT47X940EU Installation And Operating Instructions Manual

Operating the appliance
en
Adding more laundry or
removing laundry
After the programme starts, the start
delay or appliance is enabled for
remote start, you can add or remove
laundry as necessary.
Press ‹ (Start/Pause).
1.
Press Ï to open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press ‹ (Start/Pause).
5.
Press } (Remote Start) if you want
6.
to enable the appliance for remote
start.
If you pause the programme
Note:
when the door is closed, the laundry
cannot cool down. For safety reasons,
the CoolDown process is started after
30 seconds.
In doing so, the drum turns, the laundry
is cooled and the following message
appears in the display: Drum content
still hot. Cool down active. Appliance
can be used as usual.
You can interrupt the CoolDown
process by opening the door or
continuing the programme.
The programme duration is
Note:
updated on the display, depending on
the load and on the residual moisture in
the laundry. The values displayed may
change when the programme or load is
changed.
36

Cancelling the programme

Press ‹ (Start/Pause).
1.
Press Cancel.
2.
Press Ï to open the door.
3.
Remove the laundry.
4.
Caution!
Risk of fire. Laundry may catch fire.
If you cancel the programme, remove all
items of laundry from the dryer and
spread them out to allow the heat to
dissipate.

Programme end

The following message appears in the
display: Laundry is ready.
Removing laundry and
switching off the appliance
Press Ï to open the door.
1.
Remove the laundry.
2.
Press " for standby mode.
3.