0 ft. 5 ft. 10 ft. 15 ft. 20 ft. 25 ft. 28 ft. UTA02505APK 1800 1550 1320 1080 SAFETY INSTRUCTIONS Do not pump flammable or explosive liquids such as oil, gasoline, kerosene, ethanol, etc. Do not use in the presence of flammable or explosive vapors.
19. Ensure the electrical power source is adequate for the requirements of the pump. 20. Before using the pump, check the hose for holes or excess wear, which could cause leaks, and ensure the hose is not kinked or making sharp angles. A straight hose allows the pump to move the greatest amount of water quickly, and also check that all hose connections are tight to minimize leaks.
MATERIALS REQUIRED (NOT INCLUDED) NOTE: The hose and hose kit are not shown to scale. Garden Hose Sump Pump Discharge hose kit PACKAGE CONTENTS Part Description Pump 3/4 in. Check valve Debris strainer 25’ Rope SPECIFICATIONS 115V, 60 HZ., 10 Amp Circuit Power supply Liquid Temp.
Page 5
1. Connecting a check valve Install the check valve to the pump outlet anti-airlock NOTE: Be sure anti-airlock hole is pointing upward. hole 2. Connecting a debris strainer Install the “snap-on” debris strainer. Begin by lining up the pump base ...
Page 6
Drop-in pump application A1. Place hose end away from pool, where water will be displaced. A2. Attached provided 25ft. rope to handle of pump, and lower pump onto pool cover where water will collect. A3. Do not exceed the 13ft. maximum pumping height for this pump or switch may not function properly.
OPERATION NOTE: For best pump performance, unwind the hose before starting the pump. This will help remove any kinds or binds in the hose and allow the unit to pump with less restriction. 1. The water level must be at least 2” for the pump to cycle, prime, and operate. Water levels less than 2” will not allow the impeller to contact water therefore no water will be pumped.
4. To verify discharge hose is free from a blockage. a. Connect hose to another water source such as a faucet. If water flows through hose, return to step 3a.If water is restricted, verify discharge hose is unwound and remove all kinks, bends, or obstructions in hose. 5.
Page 9
September 1, 2020. K2 Pumps (K2) warrants to the original consumer purchaser (You) that its products are free from original defects in material and workmanship for at least one year (warranty varies depending on model; see box or K2 website for specific warranty information) from the date of purchase (the Warranty Period).