Junction Box Wiring Installation Instructions; Optional Brick Liner Installation Instructions - Empire Comfort Systems MILLIVOLT DVD32FP30N-3 Installation Instructions Manual

JUNctioN BoX WiriNG iNstallatioN iNstrUctioNs

caUtioN: all WiriNG sHoUlD Be DoNe BY a QUaliFieD electriciaN aND sHall Be iN coMpliaNce WitH all local,
citY aND state BUilDiNG coDes. BeFore MaKiNG tHe electrical coNNectioN, MaKe sUre tHat MaiN poWer sUpplY
is DiscoNNecteD. tHe appliaNce, WHeN iNstalleD, MUst Be electricallY GroUNDeD iN accorDaNce WitH local
coDes or, iN tHe aBseNce oF local coDes, WitH tHe NatioNal electrical coDe aNsi/NFpa 70 (latest eDitioN).
A factory installed junction box is located on the lower right side of
the fireplace. Wiring must be fed to the junction box and attached
to the receptacle that is provided. Leave approximately 6" of wire
in the junction box for connection.
Attach black wire to one side of the receptacle and white wire to
opposite side of receptacle. The ground wire should be attached
to the green (ground) screw.
Install the receptacle into the junction box. Attach cover plate.

optioNal BricK liNer iNstallatioN iNstrUctioNs

1. Using gloves, unpack liner components and check for
damaged or missing components.
2. Lower bottom louver and remove upper louver on fireplace.
3. Remove glass frame assembly from fireplace.
4. Remove rear logs from burner assembly.
5. Place brick panel (rear) against rear wall in fireplace.
NOTICE: The top edge will have a half-moon cutout relief to
match up with the rear flue vent hole.
6. While holding the front finished edge of a side brick panel (left
& right), place brick panel (sides) against side walls in fireplace.
NOTICE: The side brick panels should be installed with full
brick pattern at the bottom. Move side panels rearward until
the back edge meets the rear brick panel. Slide side brick
panels down so they rest on firebox bottom, and brick joints
match up with the back brick panel.
Page 62
staNDarD MilliVolt ValVe MoDels
7. Align grout lines on top brick panel with the grout lines on the
side brick panels. Place the top brick panel into brick panel
holder. With needle-nose pliers, carefully bend hold-down tabs
on brick panel holder over the edges of the top brick panel.
The hold-down tabs will securely hold the top brick panel in
place.
8. Replace rear logs onto burner assembly. (Refer to log
placement, pages 36 and 37.
9. Attach glass frame assembly onto fireplace.
10. Raise bottom louver and replace top louver onto fireplace.
11. Installation of optional brick liner is complete.
38713-5-1019