Table of Contents
Advertisement
screwdriver, it will return to normal.
- Changing the wireless remote control transmission code
When two indoor units are installed in the same room, in order to
prevent operating errors caused by using two remote controls, set
up the remote control [B
The unit is set to A when it is shipped.
- By adding a jumper wire to the remote control side and a carbon
resistor (1/4 W, 10 k ) to the indoor printed circuit board, it is
possible to select from 4 types of transmission codes including
one at time of delivery condition (1).
13. Troubleshooting Guide
A] switch (SW1).
71
Advertisement
Table of Contents
Troubleshooting
