Adjusting The Display Position (Ilx-F509A/Ilx-F511A); Installation Example Using The Original Mounting Bracket - Alpine HALO 9 Owner's Manual

Adjusting the display position
(iLX-F509A/iLX-F511A)
Depending on the vehicle, the front-back display position
differs. To adjust the front-back position, set the slider to the
forward position.
Default setting: Back position
1
Remove 4 hexagon bolts from both sides of
the unit.
2
Pull out the slider to the forward position. (To
return the slider to the back position, push it
in.)
3
Install 4 hexagon bolts to secure the slider.
Hexagon bolts ×4
Slider
Installation example using the
Original Mounting Bracket
1
Mount the original mounting bracket to the
unit using the supplied screws.
• If you do not have the original mounting bracket,
mount the Double din KIT* (provided with the side
mounting bracket), etc. to the main unit.
* Sold separately.
■
iLX-507A
Original Mounting
Bracket
Screws (M5×8)
(included)
Face plate (Included)
■
iLX-F509A/iLX-F511A
Original Mounting
Bracket
2
Connect all other leads of the unit according
to details described in the "Connections"
(page 76).
3
Mount the unit in a car.
• Fix the cables carefully. Do not damage them by
mounting them into movable parts, such as the seat
rail, or by locating them against sharp or pointed
edges.
4
Reattach the removed vehicle parts (panels,
etc.) or other aftermarket dash kit back onto
the vehicle.
Screws (M5×8)
(included)
73
-EN