About Ilx-507A/Ilx-F509A/Ilx-F511A; Displaying The Product Information; Updating Firmware Version; Dedicated Tuning According To Your Car (Car By Car Update) - Alpine HALO 9 Owner's Manual

About iLX-507A/iLX-F509A/
iLX-F511A
[About] is selected on the System Setup Menu screen.
By using [About], the Serial Number and Model name can
be checked, the Firmware Version can be updated, and
various settings can be initialized.

Displaying the Product Information

You can view the version information of this product. Make
note of this information and refer to it whenever you
contact Alpine Tech Support or an Alpine-authorized dealer.
Setting contents:
Serial Number / Model Name

Updating Firmware Version

Download the software from the Alpine website and
update the product using the USB flash drive.
1
Plug the USB flash drive with the update file
stored into the unit.
2
Touch [Update] of "Firmware Version".
3
After the confirmation message appears,
touch [OK].
• Do not turn on/off the power, change the ignition key position,
until system restart is completed.
Dedicated Tuning According to Your
Car (Car by Car Update)
For some car models, you can perform settings by
downloading the data of the car model from the Alpine
website. Install the data to the unit by using the USB flash
drive.
• Introduction animation, sound dedicated to the car model,
camera connection setting and camera guide line can be set
with the data of the car model.
1
Plug the USB flash drive with the update file
stored into the unit.
2
Touch [Update] of "Car by Car Update".
3
After the confirmation message appears,
touch [OK].
• Do not turn on/off the power, change the ignition key position,
until system restart is completed.
28
-EN

Displaying Software License

Setting contents:
Open-Source Software License

Initializing the Sound Settings

You can restore the EQ Setting*/X-OVER*/Time Correction*/
Media Xpander (MX)/bass engine/Subwoofer to factory
settings.
1
Touch [Set] of "Default Sound Settings".
2
After the confirmation message appears,
touch [OK].
The system starts initialization.
∗ The setting values that are stored in Preset 1 to Preset
3 cannot be initialised.

Initializing the System

You can initialize all data, to restore the factory settings.
Remove the USB flash drive, etc. from the system before
operation.
1
Touch [Reset] of "Clear All Settings".
2
After the confirmation message appears,
touch [OK].
The confirmation screen appears.
3
Touch [OK].
The system starts initialization.
• Do not turn on/off the power, change the ignition key position,
until system restart is completed.