Setting The Password; Clearing The Password; Vehicle Type Setup; Steering Wheel Setting - Alpine HALO 9 Owner's Manual

Setting the password

1
Touch [ ] (Off) of "Security Code".
2
After the confirmation message appears,
touch [OK].
The password setting screen is displayed.
3
Enter a password, then touch [OK].
• Enter the 6-digit number.
• Input numbers are displayed as "*".
• Touch [ ] to delete an entered number.
• Touch [Delete All] to delete all entered numbers.
4
Enter the same password again, then touch
[OK].
The password is set and the system returns to the
System Setup Menu screen, then the Security Code is
set to [On].
• If you forget a registered password, you can not use this unit.
In this case, service will be required.

Clearing the password

1
Touch [ ] (On) of "Security Code".
The password setting screen is displayed.
2
Enter the password you have set, then touch
[OK].
The password is cleared and the system returns to the
System Setup Menu screen, then the Security Code is
set to [Off].
• Input numbers are displayed as "*".

Vehicle Type Setup

[Vehicle Types for Phone Link] is selected on the System
Setup Menu screen.
Apple CarPlay and Android Auto require information about
the vehicle to use all functions in the best possible way.
Setting item:
Vehicle Types for Phone Link

Steering wheel Setting

Set this item when Apple CarPlay is used/Android
smartphone which installed Android Auto App is
connected.
This setting influences Apple CarPlay/Android Auto mode.
Setting item:
Steering wheel
Setting contents:
Left (Initial setting) / Right

Fuel Type Setting

Set the Fuel type of your car.
Setting item:
Fuel Type
Setting contents:
Unknown / Unleaded gasoline (Initial setting) /
Leaded gasoline / Diesel #1 / Diesel #2 / Biodiesel /
85% ethanol/gasoline blend / Liquified petroleum gas /
Compressed natural gas / Liquified natural gas / Electric
/ Hydrogen fuel cell / Other

EV Connector Type Setting

When [Electric] is selected for "Fuel Type Setting" (page
27), set EV Connector Type.
Setting item:
EV Connector Type
Setting contents:
Unknown (Initial setting) / J1772 / Mennekes / Chademo
/ Combo_1 / Combo_2 / Tesla roadster / Tesla HPWC /
Tesla Supercharger / GBT / Other

Installation Setup

[Installation Status] is selected on the System Setup Menu
screen.
Vehicle Setup enables you to check the installation status of
Camera 1, Camera 2, CAN Box, Dash Cam*, GPS Antenna,
GPS Information, Park, Vehicle Speed, Reverse, Battery
Voltage.
∗ Dash Cam is displayed in the Installation Setup, but this
unit does not support it.
Setting item:
Installation Status
The Installation check screen is displayed.
• Depending on your vehicle, some installation status may not
be checked via this function.
27
-EN