Troubleshooting Guide - Frigidaire EFIC255-GREY Use & Care Manual

PROBLEM
"Add Water"
indicator lights up
"Ice-Full" indicator
lights up
Power and ICE
icon flashing
Making Ice too
slowly
Water leakage

TROUBLESHOOTING GUIDE

POSSIBLE CAUSES
Lack of Water.
Internal water tank ba e is not
installed in place.
Water pump failure.
There are too much ice cubes.
(No ice cube inside).
Ambient temperature or water
temperature in inner tank is too
high.
Refrigerant liquid leakage.
Cover motor is broken.
The pipe in the cooling system is
blocked.
Hot Air outlet has been blocked
by something.
The water temperature in inner
tank is too high.
Refrigeration system malfunctions.
The drain plug is not in place.
Pipe joints in the appliance may
loose.
The seal has reached service life.
SOLUTION
Stop the ice maker, fill
water, and press "ICE/
CLEAN" button again
to restart the unit.
Reinstall the internal
water tank ba e in place.
Verify by a qualified
technician.
Suggest you to obtain the
ice-cube.
Remove the probable
obstacle inside or clean
the inside wall of the ice
storage.
Press "ICE" button for 5
seconds, it will work for
80 minutes.
Please run the ice maker
below 90 Fahrenheit degree
ambient and pour colder
water into tank.
Press the ICE button to
power o the unit, then
press the ICE button again
to restart ice making
program, if this problem
show up again, verify by a
qualified technician.
Hot Air outlet must be
guaranteed to have more
than 15 CM of ventilation.
Water temperature
requirement between
44.6°F -89.6°F.
Verify by a qualified
technician.
Put the drain plug in place.
Verify by a qualified
technician.
Verify by a qualified
technician.
11