Testing Mode - Pegasus W500 Series Instructions Manual

Testing mode

If truoble occurs while the AI device is used, find the cause
performing the test mode.
1.
Turn on the power while pressing PROGRAMMING
and FUNCTION
simultaneously.
The operation test display comes out.
CAUTION
CAUTION
Do not turn off the power until the operation test
display is shown. Otherwise memory may change.
2.
Proceed according to the instructions.
【The instructions are displayed as shown below.】
→
1 2
. SWITCH TEST
FUNCTION key
CUTTER key .)
3.
After the operating test is completed, press FUNCTION
key to return to the sewing display.
CAUTION
CAUTION
When any error message comes out, check the connection
of cords/air lines and the pressure of the filter regulator, and then
perform the test again. If the error is still shown, contact your local
Pegasus' sales office or representative.
Testing mode
keys
. AI SENSOR TEST (Move the differential feed lever with INC. ▲ and DEC. ▼ keys. → Press
→
3
.) . SENSOR TEST
→
6
. MOTOR STOP TEST (Press STOP key
PROGRAM PROGRAM プログラム プログラム
FUNCTION FUNCTION 機能選択 機能選択
→
4
. CLOTH SENSOR TEST
FUNCTION FUNCTION
ON
→
5
. CUTTER TEST (Press
while pressing the machine treadle.)
機能選択 機能選択