Before Entry - Pegasus W500 Series Instructions Manual

1.
Initializing the AI device
Note
There is no need to initialize the device except when data is
garbled or reset entered data.
CAUTION
CAUTION
Since the power is turned on when initializing the AI device,
the machine could start unexpectedly. To prevent accidents,
perform the following procedures very carefully.
Make sure cords and air lines are connected properly first.
Then turn on the machine.
Turn on the power box while pressing INC. and DEC. keys
simultaneously.
CLEAR ALL DATA
The screen displays
ｾﾞﾝﾃﾞｰﾀ ｼｮｳｷｮﾁｭｳ
Then all the sewing data is initialized.
(Refer to the sewing data preset at the factory before shipment.)
Note
Even if the AI device is initialized, the language mode is not
changed.
2.
To initialize the differential feed amount
After the initialization of the Al device has been completed, initialize
the differential feed amount.
Note
There is no need to initialize this amount at start-up every day.
Be sure to initialize it when you use this device for the first time.
Otherwise the device will not function correctly with the entered
data.
1.
Turn off the power of the power box.
2.
Turn on the power of the power box while pressing TEACHING
and INPUT
3.
"A.I. Initialization " appears on the screen.
A . I .
I n i t i a l i z a t i o n
several second later
S e t t h e F e e d
t o S t a n d a r d
4.
Set the standard position of the differential feed lever with
▲ ▼
INC. or DEC. key.
※ If the differential feed lever is to be placed at the standard
position with no differential feed effectiveness, set the
differential feed lever at 1 : 1.
After this adjustment, press INPUT

Before entry

▲ ▼
･
.
keys simultaneously.
appears on the screen.
key.
INC. INC.
増 増
DEC. DEC.
減 減
OFF
TEACHING TEACHING ティーチング ティーチング
INPUT INPUT 設 定 設 定
INC. INC.
増 増
DEC. DEC.
減 減
1 : 1
ON
ON
INPUT INPUT 設 定 設 定