Table of Contents
Advertisement
W
ARNING
W
ARNING
Always turn off the power, unplug the machine from
the outlet and then only well-qualified technicians should
connect the cords.
Check the voltage designation 7 to make sure the
power relay cord 1 matches the local supply voltage. The
use of wrong cord may cause damage to parts and/or fire.
1.
Each of cords and connectors is color- and shape-
coded. Connect the cords to the connectors correctly
as shown below.
Earth wire
orange
To use AI110
The connector is different in
color according to the motor.
To the machine motor
control board connector
(optional)
To connect the power relay cord 1 to the push-button
switch 2, connect E marked (green/yellow striped) wire
to the GND terminal 3.
The other two cords must be connected to any 2 of the
terminals 4, 5, and 6.
2.
Fasten the cords on the underside of the table conveniently with the provided cord clamp.
Connecting cords
white
blue
white
white
yellow
orange
white
To the machine
motor power
connector
Connect the earth wire correctly. Otherwise you may
get an electric shock when you touch the AI power box
and/or the machine.
Failure to connect properly may cause hazardous
faulty operations and damage to the machine.
● To disconnect the locking connector, hold down the locking
8
mechanism
with finger as you pull the connector out.
blue
white
orange
blue
white
Power
source
6
1
3
4
8
7
5
2
Advertisement
Table of Contents
