Programming the sewing mode
Example
PRGM
(ITEM)
:30 kinds of data for sewing items from 1 to 30 can be set.
PATTERN
:To display where to be sewn.
Data for 1 to 4 places can be set in each item.
STEP
:20 places at which the differential feed amount is changed can be set in each pattern.
DIFF. FEED
:" 00 " denotes the standard position. "
(Differential
"
" denotes differential feed for stretching. 17 steps are available.
feed ratio)
The range of "
【Refer to " (2) To initialize the differential feed amount " on page 14.】
STITCH
:The number of stitches to be produced for one step can be set.
Adjustable in the range of 0 to 999.
CODE
:To display a code for each pattern.
C (Continue): Select this code to make each pattern proceed to the next pattern.
E (End)
Ex.-1) To select each code with 3 patterns.
(1)pattern
Ex.-2) To select the code with only one pattern.
(1)pattern
Note) Be sure to select CODE " E " for an unused operation.
MODE
: To display how to sew each step.
START: Indicates the number of stitches counted from when the light from the sensor is interrupted by
CONTINUE: Indicates the number of stitches counted while the light from the sensor is being interrupted
END: Indicates the number of stitches counted from when the fabric has gone through the light from the
sensor at the end of sewing process.
COUNT
:To display the number of stitches to be produced during sewing.
The number increases as every stitch is produced.
When the number on the screen reaches to the preset one, the machine goes to the next step.
PRGM
PRGM
PATTERN
PATTERN
CODE
CODE
品番
品番
工程
工程
コード
コード
1 1
0
E
C N T
O
MODE モード
MODE モード
+
" to "
" changes according to the standard position of the differential feed lever.
: Select this code to make each pattern return to the previous pattern without proceeding to the
next pattern.
(2)pattern
(3)pattern
C
→
C
→
E
the edge of the fabric at the start of sewing process.
by the fabric.
STOP
STOP
STEP
STEP
CUTTER
CUTTER
STITCH
STITCH
ストップ
ストップ
ステップ
ステップ
カッター
カッター
針数
針数
1 ー ー
0
0
0
0
0
0
0 0
DIFF. FEED
DIFF. FEED
差動送り量
差動送り量
COUNTカウント
COUNTカウント
+
" denotes differential feed for shrinking.
Note
If sewing date are entered in TEACHING mode,
E
they are automatically set.
Therefore, there is no need to set them afterward.
0