Connect To The Nmea 2000® Network - Veratron LINK UP J1939 User Manual

SYSTEM INSTALLATION
CONNECT TO THE NMEA 2000® NETWORK
Once the LinkUp Gateway is mounted complete, it is possible
to interface it to the NMEA 2000® backbone through the
dedicated plug.
Please ensure to tighten the M12 connector by screwing it
onto its counterpart, so to preserve the water tightness.
A drop cable is not needed unless the total length of the
LinkUp device is not enough to reach the NMEA 2000®
backbone. In this case it is possible to extend the total length
by using one of the accessory drop cables.
Please note that NMEA 2000® does not allow drop cables
longer than 6 meters.
Refer to the NMEA 2000® standard for a proper network
design.
If power from the NMEA 2000® network is received, the
green LED on the LinkUp housing will start flashing (see "LED
notifications").
B001030