Failover/Failback - Panasonic TH-86EQ2W Operating Instructions Manual

■
[Changing delay]
Sets the delay time until the input is switched during
[Input detection].
[Off]: Switches the input if a signal is interrupted
even for a very short period.
1 ‒ 10: Sets the delay time (sec.).
Switches the input when the set time has
elapsed after detecting no signal is present.
However, if the detection period during
which no signal is present is shorter than the
set delay time, the input is not switched.
Note
●
[Input detection] is the function that automatically
switches the input as below by monitoring the
presence of signal for the set input.
If a video signal is input to the set input that is
•
not displayed (When the status has changed
from signal absent to signal present.), the input is
selected and switched.
If no signal is detected for the displayed input, the
•
setting switches to the set input to which a signal is
input. Also, if no signal is present for the displayed
input when the power is turned on or when the
input is switched, the setting switches to the set
input to which a signal is input. When signals are
input to multiple set inputs, the priority order as
default (immediately after power-on) is as follows:
HDMI1, HDMI2, HDMI3, USB-C, PC.
In the other case (When the input is switched after
power-on), the input displayed last takes priority.
●
[Changing delay] is the function to prevent the
accidental input switch during a short period, such as
when the signal is interrupted due to the frequency
change for the input signal while [Input detection] is
operating.
If a signal is detected again within the set period
(sec.), the input is not switched.
●
[Input detection] may not operate correctly depending
on the image playback device.
●
[PC] operates only when [PC input mode] is set to
[PC]. (see page 86)
●
[USB-C] and [SLOT] do not operate even if they are
selected simultaneously.

Failover/Failback

Automatically switches to the backup input if an
interruption of video occurs.
Note
● [PC] operates only when [PC input mode] is set to
[PC]. (see page 86)
●
[SLOT] is enabled when the DIGITAL LINK Terminal
Board is attached.
●
MEMORY VIEWER / Screen Transfer /
WHITEBOARD input is excluded from this function.
●
Depending on the image playback device or image
signal, a noise may occur on the screen, or this
function may not operate.
1. Setting the input change mode
■
[Input change mode]
[Off]:
Disables the Backup Input function.
Failover/Failback
Input change mode
[On]:
Switches to the backup input if an interruption of
video occurs.
The backup video signal does not need to be in the
same format as the (main) input in use for viewing.
Upon switching to the backup input, the video and
audio adjustment values for the backup input will
be used.
Failover/Failback
Input change mode
Primary backup input
Secondary backup input
Auto switch back mode
Backup input change
Main input
Current input
Off
On
HDMI1
HDMI2
Disable
Active
HDMI2
Main input
English
57