Panasonic TH-86EQ2W Operating Instructions Manual page 77

■
[Network status]
Checks the current Network settings status.
Network status
DHCP
IP address 192. 168. 0. 8
Subnet mask
255. 255. 255. 0
Gateway
192. 168. 0. 1
EAP
MAC address 12:34:56:78:9A:BC
■
[DIGITAL LINK mode]
Switches communication method of DIGITAL LINK
terminal.
[Auto]:
Communication method is selected automatically.
HDMI, LAN, serial communication are possible.
Ethernet connection is possible.
[DIGITAL LINK]:
HDMI, LAN, serial communication are possible via a
twisted pair cable transmitter.
[Ethernet]:
LAN communication is performed.
[Long reach]:
Communication method is fixed to Long reach.
Modes allowing communication
: Valid
― : Invalid
Settings
transmission Ethernet
100 m 150 m
For
DIGITAL
LINK
Auto For Long
reach
For
Ethernet
DIGITAL LINK
Long reach
Ethernet
Note
● When connected with the [Long reach]
communication method, the maximum
transmission distance is 150 m. In this case, this
unit can receive the signals of up to 1080/60p
(148.5 MHz).
●
If the communication method of the twisted
pair cable transmitter is set to [Long reach], set
[DIGITAL LINK mode] to [Auto]. Then, connection
is enabled with the [Long reach] communication
method.
When connecting with the separately sold DIGITAL
LINK Switcher (ET-YFB200G) with the [Long
reach] communication method, set [DIGITAL LINK
mode] to [Long reach].
Off
None
Communication validity
Picture
―
―
― ―
―
―
― ―
●
Even if [DIGITAL LINK mode] is set to [Long
reach], when the twisted pair cable transmitter
does not support the communication method of
[Long reach], it will not be connected properly.
●
When [LAN terminal setting] is set to [LAN
terminal], even if [DIGITAL LINK mode] is set to
[Ethernet], the Ethernet connection cannot be
made.
■
[DIGITAL LINK status]
Display the DIGITAL LINK connection environment.
Select [DIGITAL LINK status] with
<ENTER>.
DIGITAL LINK status
LINK status
HDMI status
Signal quality
Min
Max
[LINK status]:
1 of the followings will be displayed.
[No link]:
No LAN connection, etc.
[DIGITAL LINK]:
Connected to the DIGITAL LINK device by LAN.
[Long reach]:
Communication method is set to [Long reach] and
is connected to the DIGITAL LINK device by LAN.
[Ethernet]:
The PC is connected to the DIGITAL LINK / LAN
terminal of this product and is LAN connected.
RS-
[HDMI status]:
232C
Displays the connection status of the HDMI format.
1 of the followings will be displayed.
[No HDMI]:
DIGITAL LINK not connected
[HDMI on]:
DIGITAL LINK connected
―
[HDCP on]:
HDCP supported on DIGITAL LINK
[Signal quality]:
It is the quantified minimum and maximum numbers
―
of errors that have occurred. The display colours are
red, yellow, or blue, depending on the number.
Signal quality
-12dB or below
-11 to -8dB
-7dB or above
●
The number is represented by yellow or red if
the LAN cable is disconnected or the cable is not
shielded.
● This signal quality shows figures between the
twisted pair cable transmitter that is connected and
the display.
and press
No link
No HDMI
-XX dB
-YY dB
Display Reception
Colours Status
Blue Good
Yellow Bad
Red Terrible
English
77