Cisco uBR10-LCP2-MC28C Installation Manual page 21

Figure 12
Place the removed Cisco uBR-MC28C cable interface line card aside on an anti-static surface.
Step 8
Installing the Cisco uBR-MC28C Cable Interface Line Card in the
Cisco uBR10-LCP2 Adapter Card
Tip Make sure that you are using the ESD-preventive wrist strap.
Align the cable interface line card with the guide rails on the Cisco uBR10-LCP2 adapter card. Ensure
Step 1
that the bottom of the cable interface line card is flush with the bottom of the LCP2 adapter card.
Slide the new cable interface line card into the adapter card slowly, making sure that the card is sliding
Step 2
under the spring guides and into the guides (see
Step 3 Verify that the power connectors are aligned with those on the adapter card.
Step 4 Make sure that the screws on the adapter card brackets slide cleanly into the holes in the L-brackets.
Continue pushing on the front of the card until the connectors on the card are firmly seated in the
Step 5
connectors on the adapter card. The ejector levers on each side of the card snap into place when the card
is fully inserted.
OL-4653-01
Replacing the Cisco uBR-MC28C Line Card in the Cisco uBR10-LCP2 Adapter Card
Removing the Cisco uBR-MC28C Cable Interface Line Card from the Cisco uBR10-LCP2
Adapter Card
u B
R -
M C
2 8
C
Cisco uBR10-LCP2-MC28C Cable Interface Line Card for the Cisco uBR10012 Router
Figure 3 on page 5).
21