Table of Contents
Advertisement
en Rinse aid system
Additional power consump-
tion in kWh
The consumption values specified
are laboratory measurements determ-
ined in accordance with the currently
applicable standard using the Eco
50° programme and with the factory
value of the water hardness set to 16
- 20 °E.
12 Rinse aid system
12.1 Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the display shows "Please add
rinse aid. ", add rinse aid. Only use
rinse aid for domestic dishwashers.
Press the catch on the lid of the
1.
dispenser for rinse aid
.
30
0.05
and lift
2
1
Add rinse aid up to the max mark.
2.
If rinse aid spills out, remove it
3.
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
Close the lid of the dispenser for
4.
rinse aid.
a The lid clicks into position.
12.2 Setting the amount of
rinse aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
Press
.
1.
To open the basic settings, press
2.
for approx. 3 seconds.
Press
repeatedly until the display
3.
shows "Rinse aid dispenser".
Press
or
4.
right amount of rinse aid has been
set.
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
– A higher setting adds more
rinse aid during the wash cycle,
reduces water marks and im-
proves the drying result.
To save the settings, press
5.
approx. 3 seconds.
max
repeatedly until the
for
Advertisement
Table of Contents
