Table of Contents
Advertisement
en Water softening system
Water hardness
°E
9 - 10
11 - 12
13 - 15
16 - 20
21 - 26
27 - 38
39 - 62
Note: Set the water hardness determ-
ined on your appliance.
→ "Setting the water softening sys-
tem", Page 28
With a water hardness of 0 - 8 °E
you can dispense with special salt for
dishwashers and switch off the water
softening system.
→ "Switching off the water softening
system", Page 29
11.2 Setting the water soften-
ing system
Set the water hardness on your appli-
ance.
Determine the water hardness and
1.
the appropriate setting value.
→ "Overview of water hardness set-
tings", Page 27
Press
.
2.
To open the basic settings, press
3.
for approx. 3 seconds.
Press
repeatedly until the display
4.
shows "Water hardness".
Press
or
5.
right water hardness has been set.
The value 16 - 20 is set at the fact-
ory.
To save the settings, press
6.
approx. 3 seconds.
28
Hardness range
Soft
Medium
Medium
Medium
Hard
Hard
Hard
repeatedly until the
mmol/l
1.2 - 1.4
1.5 - 1.8
1.9 - 2.1
2.2 - 2.9
3.0 - 3.7
3.8 - 5.4
5.5 - 8.9
11.3 Special salt
You can use special salt to soften
water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser
for special salt just before the pro-
gramme starts. The consumption of
special salt depends on the water
hardness. The higher the water hard-
ness, the greater the consumption of
special salt.
ATTENTION!
Detergent may damage the water
softening system.
Only fill the dispenser of the water
▶
softening system with special dish-
washer salt.
Special salt for dishwashers can
damage the tub due to corrosion.
To make sure that any special salt
▶
that escapes is washed out of the
tub, add the special salt to the dis-
penser for special salt immediately
before the programme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
for
On initial start-up: Fill the dispenser
2.
right up with water.
Setting value
9 - 10
11 - 12
13 - 15
16 - 20
21 - 26
27 - 38
39 - 62
Advertisement
Table of Contents
