Toshiba RD-85DTSB Owner's Manual page 37

Notes
• If the recorder's mode and the remote control's mode are different, the recorder's mode (DR 1, DR 2 or DR 3) appears in the
display of the front panel.
• When the batteries of the remote control are replaced or when the time indicator of the front panel flashes, check the remote
control modes of both the recorder and the remote control, and re-program if necessary.
Disabling the remote control for a temporary period
You can temporarily disable the reception of the remote control signals at the recorder, when the selection of DR 1,
DR 2 and DR 3 is not sufficient while you are using several Toshiba HDD/DVD video recorders.
Press HDD and DVD on the recorder at the same time for three seconds or more.
The recorder display shows "DR-OFF", indicating that the remote control is disabled.
To enable the remote control, perform the same step again. (The display shows "DR-1, DR-2 or DR-3" depending on
your setting.)
RD-85DT_instE_30-39
Setting up the remote control
5
While pressing MODE, press 2 (example).
37
The remote control mode is set to DR 2.
Select the same mode that you have set to the recorder.
Mode
Recorder
DR 1
DR 1
DR 2
DR 3
DR 1
DR 2
DR 2
DR 3
DR 1
DR 2
DR 3
DR 3
3/27/06, 17:43
Mode setting
Remote control
+
+
+
37