3: Input Signal Setting - Toshiba RD-85DTSB Owner's Manual

Basic setup
A: Initial settings (Continued)

3: Input signal setting

Make a selection according to the video system of receiving broadcasts or recording sources from the input sockets.
Start
26
RD-85DT_instE_26-29
1
Press SETUP if the setup menu is not displayed.
2
Press
OK/ENTER.
3
Press
OK/ENTER.
4
Press
type, then press OK/ENTER.
26
/ to select "Initial settings", then press
/ to select "Input signal", then press
e.g.
Initial settings
Time & date setting Auto
PAL
Input signal
AV1 output Video
Video
AV2 input
On
Auto clock starts at 5:00
/ to select the video input signal
PAL : Select when viewing and/or recording PAL
signals broadcasted mainly in England.
Additionally select when recording PAL
signals from the AV1(AUDIO/VIDEO)IN/OUT
socket, the AV2(SAT/DECODER)IN/OUT
socket, or the INPUT jacks on the front panel.
SECAM : Select when recording SECAM signals from
the AV1(AUDIO/VIDEO)IN/OUT socket, the
AV2(SAT/DECODER)IN/OUT socket, or the
INPUT jacks on the front panel.
Auto : The recorder automatically identifies PAL or
SECAM video system of receiving broadcasts
or recording sources. Some signal conditions
of the broadcasts or the sources may prevent
correct detection. In this case, select "PAL" or
"SECAM" according to the broadcast or the
source.
• To exit the menu, press the SETUP button.
3/27/06, 17:43
PAL
SECAM
Auto