Table of Contents
Advertisement
Troubleshooting
CAUTION
• When returning the transport unit back inside the printer, be careful not to get your fingers caught
between the transport unit and the inside of the printer.
Connection part
IMPORTANT
• Adjust the paper guides to the paper width
Adjust the paper guides to the paper width. However, when the paper guides are adjusted to the paper width,
micro margin printing is not possible.
A
• When the paper guides are adjusted to the paper width, be careful of the following points.
-
When the paper guides are adjusted to the paper width, micro margin printing is not possible.
-
When performing micro margin printing, be sure to set the paper guides to the MM position. Otherwise, the
51
C
G
MM
51
54/55
58
MM
B
D
3. When using the stacker, install it back to
the correct position.
Insert the connection part of the stacker straight
into the slot of the printer.
1. While holding the paper guide (A) with
your fingers, adjust it to G of the index (C).
When setting paper guide (B) to a position other
than MM, adjust paper guide (A) to G of the
index (C).
2. While holding the paper guide (B) with
your fingers, adjust it to the paper width
index (D). For example, the figure on the
left shows adjustment to guide position
54.0 mm/55.0 mm.
Advertisement
Table of Contents
