Table of Contents
Advertisement
LE100/LE200
CONNECTIONS
LE Series monitors are fitted with low-profile, NL4-type four-pin push-lock connectors, rated
at 30 A. All the connectors (five on the LE100, four on the LE200) are wired in parallel: use
whichever connector(s) suit the stage cabling layout. The multiple connectors permit simple
interconnection between monitors on the same circuit; they can be used to "daisy-chain" the
amplifier output to the next speaker.
Important: please ensure that the total impedance of multiple LE Series monitors connected in
this way is not less than the minimum load impedance the amplifier channel can drive:
Wire the mating connectors according to the following pinout table:
Note that as pins 2+ and 2- are unused on the LE100, standard four-core speaker cables
terminated in NL4s may be used without a problem. However, note that all four pins on each
connector - including those that are unused by the speaker itself - are wired in parallel to all
other connectors on the cabinet.
LE100/LE200 User Guide V1.0
USER GUIDE
No. of monitors
1
2
3
4
Pin
LE100
Passive x-over
Input '+'
Input '+'
1+
Input '-'
Input '-'
1-
(not used)
(no connection)
2+
2-
(not used)
(no connection)
Total impedance
8 ohms
4 ohms
2.7 ohms
2 ohms
LE200
Bi-amped
LF input '+'
LF input '-'
HF input '+'
HF input '-'
7
Advertisement
Table of Contents
