LE100/LE200
It can be seen from the the views above that the coaxial driver is not symmetrical. For correct
performance, the driver should always be orientated as shown, with the "butterfly wings" of the
HF driver assembly biased towards the bottom of the enclosure.
To rotate the driver, proceed as follows:
1. Place the enclosure face-up on a bench, table or other suitable flat surface.
2. Follow the instructions for grille removal in the following section "Grille removal and
3. Using a 5 mm AF hex key, remove the eight screws securing the driver to the baffle
4. Gently lift the driver assembly out, rotate it through 90° and replace it.
5. Refit the screws removed in Step 3.
6. Follow the instructions for grille replacement in the section "Grille removal and
7. Follow the instructions in the section "Badge rotation" on page 16.
LE100/LE200 User Guide V1.0
USER GUIDE
replacement".
board.
replacement".
13