Cleaning And Maintenance; Remote Control - Comfort Zone CZPH25RSLS3 Series Manual

OPERATING INSTRUCTIONS:
Manual Operation:
Use the rocker power switch on the right panel to manually
control the heater if you don't have the remote control nearby.
1. POSITION « I » powers ON the heater and keeps it
on HIGH heat setting.
NOTE: When using the heater in manual mode, it will
work only on the HIGH setting. To change heat settings to
Medium or Low, you need to use the remote control.
2. POSITION « II » powers ON the heater, and allows you
to adjust the heat settings using the remote control. In
POSITION « II », you will see a red light behind the front
panel. At this point, press the ON/OFF button on the
remote control and you will see the red light turn green.
Now you can adjust the heat settings using the remote
control.
3. POSITION « O » powers OFF the heater.

REMOTE CONTROL:

1. Function Button: On/Off/Standby.
2. To use the remote control function,
put the rocker power switch on
the heater to POSITION « II », then
press the ON button on the remote
control. Choose low, medium or
high heat setting on the remote
control.
The rocker switch must be on
POSITION « II » for the remote
control to work.
IMPORTANT SAFETY FEATURE:
This heater has a tip over protection function, which means
when the product incline is 15 degrees or more, the tip over
switch will be engaged and the heater will be power off
automatically to ensure safety. The tip over switch will reset
when the heater is no longer on an incline of 15 degrees or
more.
www.comfortzoneproducts.com

CLEANING AND MAINTENANCE:

Maintenance:
Unplug the power cord. Inspect the wire grille, heater body,
power cord and plug periodically. In case of damage or
defect, consult an electrician.
Unplug power
WARNING:
electrical or mechanical functions on this heater. The
unit does not contain any user serviceable parts. Only a
qualified electrician should perform servicing or repairs.
Heater Exterior Cleaning:
Before cleaning the heater be sure to disconnect the heater from
the power supply and allow the heater to cool completely. Clean
the outside surface with a clean damp cloth. Do not use harsh
chemical or abrasive cleaners. DO NOT IMMERSE THE HEATER
IN WATER. Allow heater to dry completely before use.
Never unplug your heater by
cord. pulling on the power cord.
DO NOT attempt to repair or adjust any
5
5