Related Manuals for Comfort Zone CZ2032O
Summary of Contents for Comfort Zone CZ2032O
- Page 1 CZ2032O – Oak Finish CZ2032C – Cherry Finish CZ2032W –Walnut Finish QUARTZ INFRARED HEATER OWNER’S MANUAL PLEASE SAVE THESE INSTRUCTIONS...
-
Page 2: Important Instructions
WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE. Thank you for choosing a Comfort Zone® Infrared Heater. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new heater. -
Page 3: Specifications
To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on the plug, DO NOT unplug by pulling on the cord. Always unplug the unit before moving or cleaning, or whenever the heater is not in use. Use only for intended household use as described in this manual. -
Page 4: Product Diagram
WARNING: This heater has a voltage rating of 120 volts. The cord has a plug as shown in (A). An adapter as shown in (C) is available for connecting three-blade grounding-type plugs to two-slot receptacles (B). The grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. -
Page 5: Control Panel
CONTROL PANEL 1. Signal-receiving window: for receiving remote control signal. 2. Digital display indicates set room temperature or time value of the timer. 3. Power indication light: indicates when the unit is connected to power supply and rear master power switch is on. 4. - Page 6 Mode button: used for mode selection Power button: used for power-on or power-off Temp up button: to make set temperature higher Temp down button: to make set temperature lower Timer button: used for setting timer and adjusting time value of the timer Remove clear insulating film from remote control battery before remote control use Remote Control Clear Insulating Film...
- Page 7 OPERATING INSTRUCTIONS 1. Start and select working mode With master power switch at the rear of the unit on, turn the heater on by pressing the POWER button on the control panel or by pressing the Power button on the supplied remote control.
- Page 8 3. Setting timer-power-off Note: ONLY under power-on mode can you set timer-power-off function. Timer function not an excuse to leave heater unattended. After starting the unit, press the timer button on the control panel or remote control. Digital display changes from set temperature to time value for the timer.
-
Page 9: Maintenance
MAINTENANCE 1. Turn off the power switch in the rear of the unit. 2. Unplug the unit and let it cool completely. 3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. -
Page 10: Troubleshooting
STORAGE Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the original packaging to repack the unit. TROUBLESHOOTING If the heater will not operate, please check the following before seeking repair of service: 1.
Need help?
Do you have a question about the CZ2032O and is the answer not in the manual?
Questions and answers