Programming Chart - CDVI SOLARKPW Installation Manual

MANUEL D'INSTALLATION
SOLARKPW-SOLARKPB
Dual Technology Digicode

14] PROGRAMMING CHART

Default values
- Illumination duration: 10 seconds
(in standard mode),
- User code lenght: 5 digits,
- 26 bit wiegand output in direct mode,
- Buzzer abled,
- permanent mode keypad + tags.
Programming
illumination
keypad
A0
1 beep
Green LED ON
Enter the illumination
time in seconds fron
02 to 99 seconds
1 beep = OK
Green LED ON
4 beeps = Error
B
To recover the factory master code:
- Press successively on terms 1 3 9 7 5
by keeping the pressure for 5 secondes
per digit.
- One beep is emitted and the Green LED is lighting
up during 1 second to validate the operation.
cdvi.com
16
cdvigroup.com
/Proximity reader - Wiegand
®
Programming
the code lenght
A1
1 beep
Green LED ON
Enter:
4, 5, 6, 7 or 8 to specify
the number of digits.
1 beep = OK
Green LED ON
4 beeps = Error
B
Number of digits:
- 7 digits allowed in 30 or 44 bits only,
- 8 digits allowed in 44 bits only.
Permanent Mode:
The keypad is permanently illuminated
and the reader is ON.
Audible Signal
- 1 short beep > keypad powered
and key presses,
- 1 long beep > data computing
in programming,
- 2 short beeps > Entry or Exit
from programming,
- 4 short beeps > data computing error.
Programming the
Bit format
A2
1 beep
Green LED ON
Enter: 26, 30 or 44
to defi ne the Bit number
of the Wiegand format
1 beep = OK
Green LED ON
4 beeps = Error
B
EN
Programming
Centaur or
Standard format
A4
1 bip
LED verte ON
Enter:
- 0 = for hexadecimal
mode (A & B are not
used)
- 1 = for decimal mode
(Direct mode, A is allowed)
1 beep = OK
Green LED ON
4 beeps = Error
B