GE Fuji Electric AF-300 Mini Startup Manual page 66

y codes: LINK Functions
y01 RS485 setting (Station address) 1 to 255
y02 (Mode select on no 0_Trip and alarm (Er8)
response error)
y03
y04 (Baud rate) 0_2400bps
y05 (Data length) 0_8 bit
y06 (Parity check) 0_No checking
y07 (Stop bits) 0_2 bits
y08 (No response error 0_No detection
detection time)
y09 (Response interval) 0.00 to 1.00s
y10 (Protocol select) 0_Modbus RTU protocol
y99 Link function for
supporting data input
*1) Change during operation
N Disable.
Y Settled by FUNC/DATA key.
Y* Changed by UP/DOWN key
and settled by FUNC/DATA key.
Note1:The above Setting ranges may be limited by the singns or the number of digits.
Note2:Do not change the settings in E45 to E47,H71 and H95, as Driive does not use them although they are displayed.
1_Operation for y03 timer, alarm (Er8)
2_Operation for y03 timer, and retry to communicate.
If retry fails, the drive trips (Er8).
3_Continuous operation
(Timer) 0.0 to 60.0s
1_4800
2_9600
3_19200
1_7 bit
1_Even parity
2_Odd parity
1_1 bits
1 to 60s
1_SX protocol (Loader protocol)
2_Fuji general-purpose drive protocol
(Select) (Freq. setting) (OPR command)
0_by H30 by H30
1_RS485 by H30
2_by H30 RS485
3_RS485 RS485
0.01
5-8
1 - N 1
- - Y 0
0.1 s Y 2.0
- - Y 3
- - Y 0
- - Y 0
- - Y 0
1 s Y 0
s Y 0.01
- - Y 0
- - Y 0