GE Fuji Electric AF-300 Mini Startup Manual page 43

If you press the or key in any conditions other than those described above, the following will appear:
Frequency command
Frequency
from communications
command 1 (F01)
link
0 Disabled
Other than the above
TIP:
• When setting the frequency and others with the / keys, the lowest digit on the display will flash. Change the
setting, starting from the lowest digit and the cursor will move to the next digit to be changed.
• When the data is to be dump-changed, hold down the
move to the next digit where the data can be changed (cursor movement).
(3) Monitor the Running Status
In Run mode, the seven items listed below can be monitored. Immediately after the drive is turned on, the monitor
item specified by function code E43 is displayed. Press the
Monitor Items
Speed monitor
(Hz, rpm, m/min, min)
Output current (A)
Power (kW)
Output voltage (V)
PID process command (Note)
PID feedback amount (Note)
Timer (sec) (Note)
NOTE: The PID process command and PID feedback amount are displayed only under the PID control using a
process command (J01 = 1 or 2). The timer (for timer operation) is only displayed when timer is enabled (C21 = 1).
Figure 3.3 shows the procedure for selecting the desired monitor item.
Multistep
PID control
frequency
cancelled
command
PID enabled
Disabled
Cancelled
PID enabled
Cancelled
Table 3.3 Monitor Items
Display Sample on
Meaning of Displayed Value
the LED monitor
50.00 Refer to Table 3.4.
1.90A Detected value
0.40P P: An alternative expression for kW
200U Commanded value
10.00
(PID process command or PID feedback amount) × (factor A – B) + B
PID factors A and B: Refer to function codes E40 and E41
9.00
6 Remaining effective timer count
3-7
Displayed using or
Frequency command by keypad
PID output (as final frequency command)
Manual speed command currently selected (frequency
command)
key for 1 second or longer, and the flashing cursor will
key to switch between monitor items.
key