Configuring the NSS
Configuring the Computer Network Settings
STEP 1
STEP 2
NSS3000 Series Network Storage System Getting Started Guide
This chapter describes the steps you need to follow to configure the NSS, and
includes the following topics:
•
Configuring the Computer Network Settings
•
Logging into the Configuration Interface
•
Running the Quick Setup Wizards to Configure the NSS
•
Saving the NSS Configuration
For a detailed description of the configuration options available, see the NSS3000
Series Network Storage System Administration Guide available on Cisco.com at
www.cisco.com/go/smallbiz, or refer to the online help on the NSS
configuration interface.
The NSS ships with its network interface configured for DCHP. This is the default
configuration. If a DCHP server is installed on your network, skip this step.
If there is no DHCP server on your network, you must manually configure the
computer network setting as follows:
Set the IP address and subnet mask to the following:
•
IP Address 169.254.
254). For example, 169.254.200.30. Make sure that you pick an address that
is different from the address of the NSS chassis.
•
Subnet Mask 255.255.0.0.
Log into the NSS configuration interface. Configure the NSS network IP settings as
required.
x
y
x
y
.
(where
and
can be any number between 1 and
3
12