To Replace Failed Hard Drives - Alarm.Com ADC-CSVR2000P Installation Instructions
Hide thumbs
Also See for ADC-CSVR2000P:
- Manual (2 pages) ,
- Installation manual (16 pages) ,
- Quick start manual (3 pages)
Table of Contents
Advertisement
8. Below is an example image of the inside of the enclosure after installation of the hard drives. The label side of the
hard drives should be facing up.
9. Slide the top cover back onto the chassis. Using a screwdriver, re-install screws onto the sides and back of the
chassis.
10. Enroll the device. For more information about how to enroll the device, see
(ADC-CSVR2000P/2008P/2016P) - Installation
To replace failed hard drives
1. Verify that the device has no power and is unplugged.
2. Using a screwdriver, remove the screws on the sides and back of the chassis.
3. Remove the top cover of the chassis.
4. Using a screwdriver, remove the screws from the bottom of the chassis to loosen the hard drives.
https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Video_Devices/Commercial_Stream_Video_Recorder_(...
Guide.
Commercial Stream Video Recorder
Updated: Thu, 14 Apr 2022 20:22:51 GMT
2
Advertisement
Table of Contents
Need help?
Do you have a question about the ADC-CSVR2000P and is the answer not in the manual?
Questions and answers